Showing posts with label wavelet transform. Show all posts
Showing posts with label wavelet transform. Show all posts

TIA weather analysis

Here are some snaps of Tribhuvan International Airport weather analysis using wavelet. Multi Resolutional analysis is used. The snaps are respectively Air temperature, Rain fall, Relative humidity and Wind speed.





Wavelet for Climate Data Analysis

Though there are a lots of factors affecting climate time series, non-linear interaction between different scales or interference of frequency component from its sidebands is associated with amplitude modulation which can be seen with frequency components in Fourier Spectrum without time information.

If some fundamental physical properties of the climate system undergoes secular changes which is followed by frequency modulation. Some of physical properties are increase in moisture content due to global warming. If the there is not finite time of occurrence then Fourier Spectrum is not sufficient to get dominant frequencies.

Another properties associated, abrupt change in frequency of climate time series is due to occurrence of catastrophic event with long term impact, which can be analysed with spikes or peaks with corresponding frequencies in Fourier Spectrum but contains no time information at which such abrupt changes occurred.

Similarly, another short term effect associated with sudden finite amplitude perturbation. This is specially due to volcanic eruption which causes global temperature variations, which can be detected in Fourier Spectrum with large number of component without time information.

For this all Wavelet Transform could be better solution which can give time information as well as frequency information though both time and frequency information could not be determined at the same time according to Heigenburg Principal, small frequency band can be localized at the small time interval.

Continuous Wavelet Transform

Transformation of any function into its wavelet transform constitutes following simple steps:

1. take a section of the function and compare it to wavelet (mother wavelet)
2. calculate correlation coefficient
3. shift the wavelet to right
    * repeat the steps 1 and 2.
4. scale (stretch ) wavelet function
    * repeat steps 1 to 3.
5. Repeat the steps 1 to 4 for all scales.


Admissibility of Wavelets

To be classified a function as wavelet function some mathematical criteria must be satisfied and the criteria is admissibility condition. Two major admissibility conditions are:

1. Wavelet function should be of finite energy.
     $$ E= \int_{-\infty}^\infty |\psi(t)|^2 dt < \infty $$

2. Wavelet function should be of non zero frequency components that is zero mean function.
     Fourier transform of wavelet is given as:
    $$ \psi(f) = \int_{-\infty}^\infty \psi(t) e^{-2 \pi f t}dt $$
   then admissibility constant Cg is given as:

   $$ Cg = \int_0 ^\infty \frac{|\psi(f)|^2}f df < \infty $$
   This implies that wavelet has no zero frequency component ie. zero frequency component should not be exist.

Wavelet Transform

Wavelet is the newly emerging transformation theory, where you transform real signals into frequency and time domain at the same time so that the time range of occurrence for some band signals could be found. In this transformation, translated and scaled wavelet function is convoluted to the signal to be analysed.


Wavelet transform of impulse function at t=500 with haar wavelet as basis function.



Wavelet technology could be best available compression technologies with complete reconstruction of original signal with no information loss. Being always lossy compression with DCT compression technology, wavelet transform can be used for lossless compression. In any compression technologies, larger the number of transformation coefficients near to zero higher the compression ration is. Lager the number of coefficient made zero which are near to zero, higher the information is lost and the compression is lossy.